now it needs a beard

But u didn't use the flower ones 👌

I did on my heroes, but I dont have any more 😢

Only small rats left on the broodmother before shes done. However im doing them in 6 different colours so will take some time 😛

How much did you slap on them? Are they turned into bushes now?

Just kidding

Only one for each

Good luck

Looks good.

Hi everyone, I have a problem with my primer, it's rubbing off. I primed yesterday with an airbrush: ProAcryl Primer thinned a little with Thinner and Flow improver. This has never happened before. Anyone an idea what might be the cause?

maybe it's because I have never had such great minis before... seriously the sculpts of these minis are insane...

Feeling alright about this one

I think it's good

Thanks!

The shield being white is super different. I'm a fan

I probably should do something with it so it’s not so white but I redid it like 5 times cause I kept ruining it trying washes and stuff

Na the white is really clean looking. Makes him look all holy or something. Just say his shield is white because it represents himself as the shield for everyone else. Taking the incoming hits as part of his atonement

Love it!

I got myself AK interactive airbrush primer that also needs to be thinned. I don't have experience that it worked good so far, its a terrible primer. I stopped using it and I decided to use it on trimming the bases, but its terrible for that too. Maybe you need to wash your minis first, but in my opinion that primer is terrible and you should get the one that doesn't have to be thinned.

Oh, cool a white shield says my son 👍

@Crash thanks for your feedback. Actually, so far I never had a problem with this primer. I had also washed the minis before. Maybe the heat also affects airbrush priming? Now I am unsure though how to proceed. I think I will varnish the mini I have painted and see if that helps.

@Aztrix cool idea with the white shield!

Its hard to figure out what is actually a problem, since I didnt have a lot of problems with priming minis. Maybe there is too much thinner or flow improver?

@Crash I only added a few drops so the airbrush doesn't clog. So the ratio was 1:4 or even less. But I had to make several cups as I primed the 12 heroes, the allies and the rats. I will check now if all the minis have this problem. Maybe I made a mistake in one of the mixes...

I hope other are fine

@Crash okay, it's actually only the heroes and not all of them chip as easy as the figure I was painting. So I must have made a mistake in one of the mixes. Thanks for helping me figuring this out! I am glad it's not all the minis.

Thats great to hear, mate.

My game is finally on its way to me...Yay! My area is a very wet weather pattern at the moment and will be for a little while...boo!

Any recommendations for priming in high humidity conditions?

How are you planning to prime? Airbrush? Can? Bring em inside to the A/C after you hit em outside?