but can cotton wool cover it well enough once you go to town with your primer

well ill have to go in a thinking box 😄

I just went in hot & primed it all!

I'M A LOOSE CANNON!!

Not the mystery boxes before playing, surely!

Of course not. I'm not a monster

Can confirm, push fit works fine post prime.

Painting armory kinda sucks tho

Lol

Add it to the lists of reasons I'm glad I didn't buy the Armoury Box.

So I did all this taping for nothing 😅

Yes

Team “The Dancing B*stards” are ready for the wire road.

My plan for armory is that I paint the weapons as needed, if I swapped a weapon in last session, I will have it painted for the next. Unless, I ran out of things to paint. For the first session, I do want to have 4 heroes we chose (with basic weapons only), 4 allies (in case they are needed), Broodmother, all her rats and the scenary. I am done with Scenary, Broodmother, Rats, 1 Ally, 1 Hero, Now try to get rest before weekend... Its sort of hard to predict, but I do think I have good chance to get heroes done or battle ready the very least.

How are you guys painting the bosses? Waiting until you open it to set up the encounter l, then pausing, painting then playing? Or are you opening one ahead? Something else?

The first, pausing until reaching encounter. However the first encounter is known, so I could prepare to this one.

I just got it today so we started with the terrain. (The cabins). Feel like I’m going to be painting forever.

Terrain is large, but drybrushing does give good results. I will post my progress shot at some point when I have them all setup 🙂

Finally got some priming done today, got 6 Oathsworn, the men at arms and most of the broodmother done Ran out of paint at that point but I still need to prep the other models anyway They look great even just with the primer on and can't wait to get a bit of colour on them now

Depends if you use a Airbrush or a cane for priming

?

Hehe. Not sure how it would matter. Both spray on prime. I used a rattle can fwiw

Some of the primer scrapes off the male push fit joint which was fine. It's a little tight but not so much I had to get out some pliers to get it in there.

A rattle can has a thicker spray and particles than an Airbrush. Could probably thicken up the joints faster if the priming is to long

But if it worked fine 🙂 good 👍

Ah. Didn't know that!

So airbrush would be better but I can't be bothered to clean it.