Then using automated VM creation with fixed mac address for auto deploy & dhcp reservation

So thecompany just do case mount, no software on top?

They do XS but I have the Wwco vms which they load through a tool we created

I am migrating it all to clm

Ok, nice thing is with new servers they will automatically pxe boot and install, no need for screen

That's what I need to do

I mark all mine with ip adr & mac adr

Well need to teach them

Indeed, when I'm after my courses I just start pxe/tftp/ftp service and all 8x reinstall in an hour :-)

That's very cool

On the road again, dm later

Ok sounds good thank you and be safe

Prototyping, seems like there's even a space for a Skull all the way 2 the left

air flow be an issue?

No, that on each side so should okay

Run the this close at home & master class

Worst problem now is net cable & hdmi, might need 90 degrees

Or left/right cables

finger space to turn on or off ok??

That's what plugs and plug strips are for. 😝

yes there's finger space, but think about setting auto start at power off and PXE at first boot order. that way, on plug and they will start, when I want to re-install, just start pxe/ftp/tftp server and they will reinstall with hooking up keyboard & screen

that case is small @User not much bigger than your carry on, just a bit wider, its a puzzle......

main problem is power supplies space below the fake bottom

I use the power strip to set the height of the false bottom

I also use a 4 power splitter

To plug the small mic power bricks into

ClearMax 1-to-4 Power Cord Splitter Cable -18" Inches - Black https://www.amazon.com/dp/B01IRIQSY8/ref=cm_sw_r_cp_api_lMe1ybV40EKVW

This message was deleted.

Any one with experience with FreeNAS 10?

Had some issues with the iSCSI not starting.. on the 10.0.0 release - but now its 10.0.2 - maybe fixed..