https://linen.dev logo
Join Discord
Powered by
# les-ras
  • c
    as it is averaging the eddies
  • l
    and so I tried in 2D, WALE gave the best from what I tried. Smagorinsky was robust and gave results, but much lower frequency than the experimental one all the dynamic models crashed
  • c
    I dont know much about these models
  • c
    Can you suggest a test case?
  • c
    Did you try DDES
  • c
    ?
  • l
    no
  • l
  • l
    the final goal was to do FSI on it.
  • l
    and weirdly, the fluid part was the problem 😄
  • l
    2D FSI worked well, it would have most likely worked in 3D also. It was just too time consuming for the time I had
  • c
    hmm
  • c
    Do you have the simulation test case?
  • l
    eeeeeeh
  • l
    i have probably 500 of them
  • c
    ha ha
  • c
    Which version of OpenFoam?
  • l
    then again, it's also about the boundary condition. I never managed to make the good_inlet_bc_that_i_forgot_the_name work
  • c
    Okay
  • c
    I want to run for uniform flow only
  • c
    to start with
  • l
    if you didn't read this channel, you should go up
  • l
    it's not long and some things might interest you
  • c
    sure
  • c
    🙂
  • l
    also, there is this GIGO rule in CFD (Garbage In - Garbage Out), it's even more true with LES
  • l
    you need a very good mesh
  • l
    in term of everything
  • c
    Can you share a tutorial case with me? So that I try to understand the parameters.
  • c
    I agree that mesh plays a key role in turbulent simulation
1...567...52Latest