This message was deleted.

I run it every time I open a golden image. Most of it will already show optimized, but as times goes on, sometimes things would get undone and it will catch it and set it back.

Ahhh

so when you say golden image, that not when you updating a vdisk through versioning, correct?

Yea for pvs, MCS would be snapshot but ideally same thing

gotcha

I capture the image in a PVS vdisk to get it into the pvs vdisk farm. Then I do my optimizations and then do them on every update

bis-f runs it for me every time the disk is sealed.

I done that as well. But being I have custom additions I haven’t went back to update it yet. But very good point

Every time

I never used bis-f...is it a complicated tool to use or simple like the citrix optimizer tool.

it has even support for ctx optimizer

Very simple. You can configure all Settings via GPO

Yea the GPO part is. But if you have custom for things you don’t want the defaults to do, then it’s different some

Reading the Documentation is always a Good Start for bis-f