This message was deleted.

I had to on some for EPA reasons

I’ve had to do it before with 3rd party MFA stuff

I used to have to do that everytime for all the 10, 11s and 12.x upgrades. Major build upgrades over time, i had to always make sure to do Nocache for a bit of time before upgraded to prevent against the dreaded 'white screen' issues, etc.

Do any of you mind sharing the one-liner config for it?

ty, sir

that should be it, this is what i use for EPA type stuff, https://support.citrix.com/article/CTX464137/epa-failure-access-denied, and apply to select Gateways.

@Ryan Gallier Yea, I just always did it command line and will bark about licensing as many of mine didn't have licensing for caching in general, but caching is always happening for objects so it will always spit back about "not being licensed" if not premium which is accurate, but it is still happening for these global objects buckets. Our boy Jason has this old blog on it which I used for all major upgrades over the years with the 10s, 11, 12s, etc. I don't use it for minor build upgrades. Just going up major. But I have noticed past the 12s, I haven't seen this a problem like it used to be almost guaranteed or at least greater than 50% I was going to see it when jumping up major build versions. https://www.jasonsamuel.com/2016/09/13/fixing-the-citrix-netscaler-gateway-blank-page-issue-when-upgrading-from-11-0-to-11-1/

Nice, thank you guys very much