So far so good, only concern is I wish I could run claude code in YOLO/dangerous perms when doing this because it'll time-out if I leave it and it gets stuck on a permission check. Initialy I had claude code running it's new sandbox mode, but that required manually permitting adding the artifact at the end each time. I turned it off, and it still required me to do so - and I'm afraid to enable all permissions while outside the sandbox. Perhaps there's a way to choose an artifact mode that is in the local project folder? It's throwing the sandbox error because it's trying to access .traycer in my home folder, not in the project folder. Not sure if that was intentional.