Toit

Hello Friends,
I am looking for a newer board for my first Toit setup.  This one sounds quite good.  Is it supported?
https://www.adafruit.com/product/5477
Is the PSRAM version also supported?

Thanks for you attention.

The esp32s3 envelope has spiram enabled by default.
If the feather uses octal spiram (faster) then you would just need to use the esp32s3-spiram-octo envelope.

My (short) Internet search seems to indicate that the feather doesn't use the octal mode, so just "esp32s3" (as envelope) should be enough.

I was able to just run `jag flash --chip esp32s3` and it worked, but not sure if that will work in all cases for the reasons <@918882589060792390> mentioned

Damit! After I have exposed this board on this thread, it has been sold out! 🤬