https://toitlang.org/ logo
Join Discord
Powered by
Jag scan + IP connection refused. Serial monitor s...
# help
t
I just flashed Toit on an ESP-32 S3 devboard, after setting the correct chip the flashing works fine. However I can't connect with it over Jag scan, even when I specify the address. It says 
Error: Get "http://192.168.2.24:9000/identify": dial tcp 192.168.2.24:9000: connect: connection refused
Over the serial interface I get:
Copy code
I (525957) example: Socket created
I (525957) example: Socket bound, port 3333
I (525957) example: Waiting for data
E (535967) example: recvfrom failed: errno 11
E (535967) example: Shutting down socket and restarting...
Couldn't find anything in the help or the docs. Does anyone know what is going on? Flashed version 2 alpha
f
This is a new one...
Could you try to connect to the device with a browser?
To see if there is a similar error message then?
Maybe also from a different machine (like your phone).
Also, right now I don't see where the "example" comes from.
Are you certain the output (from the serial port) is from a device that was flashed with Jaguar?
t
Thanks for the quick response! Your question regarding if the device is actually flashed with Jaguar will make me re-check the flashing process. Will do that now and I'll post the results
I had some problems with flashing apparently, the default baud rate of 921600 gave me problems 
A fatal error occurred: Unable to verify flash chip connection (No serial data received.).
When I changed this rate the flashing went fine, the initial error was caused by the board not running Jaguar. Sorry for the inconvenience, I was rushing it a bit I suppose!
f
No worries. A few (but not many) boards don't support high baud rates. More commonly it's the cable that isn't good enough. Glad it works now.
PreviousNext
Powered by