https://linen.dev logo
Hello, Following up on my previous post, I rebuilt...
# general-help
c
Hello, Following up on my previous post, I rebuilt the mesh with blockMesh only. no snappyHexMesh, and it works much better. The mesh artefacts and the velocity jumps are gone. The cross-section now shows clearer secondary currents. If I zoom a little closer, the directions seem to alternate between the rows. Not very sure if this is expected, otherwise in areas with stronger secondary current, the situation looks quite good. So my setup is: - simpleFoam, LRR - Mesh with ~6.1m cells, with size 4x4x4 mm^3 each - Rigid lid assumption to simulate the flow's free surface, using symmetry patch I have 2 further questions. 1. I compared the streamwise velocity along a transverse line just below the surface with the profile in the paper. The shape is somehow similar, but my peaks sit too close to the side walls, compared to the velocity profile in the paper. What would be the first thing I should tweak to adjust the velocity profile? 2. I expected to see some horizontal vertex structures at the surface along the interface, although this is not explicitly mentioned in the paper. However, I can't see any In my results. I tried plotting vectors of (U_X, U_Y) and (U_X − U_X,ave, U_Y) on a plane below the lid. Is this a sign that my rigid-lid setup is wrong? Or should I try with pimpleFoam?