Yes, it is possible to enable pagination for your new connection in the Airbyte UI. Pagination is a mechanism used by APIs to split data into "pages" when returning results, so that the entire response data doesn't need to be returned all at once. This can be particularly useful when dealing with large amounts of data. Here are the steps to enable pagination: 1. In the Connector Builder, there is a Pagination section which implements the most common pagination methods used by APIs. When enabled, the connector will use the pagination configuration you have provided to request consecutive pages of data from the API until there are no more pages to fetch. [source](https://docs.airbyte.com/connector-development/connector-builder-ui/pagination/) 2. Check the documentation of the API you want to integrate to find which type of pagination it uses. Many API docs have a "Pagination" or "Paging" section that describes this. [source](https://docs.airbyte.com/connector-development/connector-builder-ui/pagination/) 3. The following pagination mechanisms are supported in the connector builder: - Offset Increment - Page Increment - Cursor Pagination Select the matching pagination method for your API and check the sections below for more information about individual methods. [source](https://docs.airbyte.com/connector-development/connector-builder-ui/pagination/) If none of these pagination methods work for your API, you will need to use the low-code CDK or Python CDK instead. [source](https://docs.airbyte.com/connector-development/connector-builder-ui/pagination/) For partitioning, there are three possible sources for the partitions that need to be queried - the connector itself, supplied by the end user when configuring a Source based on the connector, or the API provides the list of partitions on another endpoint. [source](https://docs.airbyte.com/connector-development/connector-builder-ui/partitioning/) To configure static partitioning, choose the "List" method for the partition router. The "partition values" can either be set to a list of strings, making the partitions part of the connector itself or delegated to a user input so the end user configuring a Source based on the connector can control which partitions to fetch. [source](https://docs.airbyte.com/connector-development/connector-builder-ui/partitioning/) I hope this helps! If you have any other questions, feel free to ask.