I trying to deploy airbyte on Ubuntu 22.04.3 LTS but i getting error like:

airbyte-webapp                    | 20-envsubst-on-templates.sh: Running envsubst on /etc/nginx/templates/default.conf.template to /etc/nginx/conf.d/default.conf
airbyte-webapp                    | /docker-entrypoint.sh: Launching /docker-entrypoint.d/30-tune-worker-processes.sh
airbyte-webapp                    | /docker-entrypoint.sh: Configuration complete; ready for start up
airbyte-webapp                    | 2023/10/23 05:17:51 [emerg] 1#1: socket() [::]:80 failed (97: Address family not supported by protocol)
airbyte-webapp                    | nginx: [emerg] socket() [::]:80 failed (97: Address family not supported by protocol)

How can i fix it?

Based on the information provided in the extracts, it seems like you're encountering an issue related to IPv6 with Nginx during the start of the Airbyte webapp. This issue is likely due to the presence of the

[::]:80

line in the Nginx configuration file. Here's a potential solution that was suggested by a user facing a similar issue: 1. Stop the webapp container. 2. Remove the webapp image. 3. Rebuild the webapp image using the local config (where the IPv6 related line has been commented out) - aka disable the IPv6 listener line. 4. Rebuild the proxy image since it has a dependency on the webapp. 5. Re-run the services. However, the user didn't provide specific commands on how to perform these steps. If you're not familiar with Docker, you might need to look up the commands or ask for further assistance. Please note that this is a potential solution based on a similar issue and might not work for your specific case. If the problem persists, I recommend reaching out to the Airbyte community on their [forum](https://discuss.airbyte.io) for more specific assistance. [Source](https://discuss.airbyte.io/t/3348)